Setting up a Brick Paver Walkway or Cement Hollow Bricks

The usage of Bricks or Pavers to create a sidewalk or outdoor patio matches a house in a method that is unmatched. In addition, setting up a Brick or Paver pathway does not necessarily need a pro.

The key to installing a Brick or Paver Walkway is to very first appropriately prepare the area where the bricks/pavers are to be installed. In addition, string lines need to be strung on each side of the walkway.
As soon as the location has been dug down, 3/4" gravel stone ought to be laid in and tamped down securely. The height between the tamped down sand and the stringline should equate to the density of the brick or paver.

Now that you have a steady base, position a 1" pipe or journal board the length of the sidewalk on either side of the pathway. Then utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will produce a level area to lay the bricks/pavers.

Now location on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared area. These strips will act as your sidewalk border and help to maintain the integrity and shape of the walkway. You can get these plastic strip borders at many house improvement stores. The strips should be anchored down with 12" galvinized nails. You need to sink these nails into the ground and through the strips every foot.

The key to laying the bricks/pavers is to ensure that they interlock with each other. Always stagger nearby rows of bricks by 1/2 of a brick to interlock them. This will again help keep the integrity of the pathway.

Undoubtedly bricks/pavers will require to be cut or divided when constructing the walkway. To really cut/split calcium silicate brick the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the area where you desire to break the brick. If your pathway has curves you will require to buy/rent a wetsaw.

After installing the bricks, construct up the outside edges with extra sand, and then shovel in the topsoil and load down firmly.
Spread stone dust over the brand-new pathway and sweep into the cracks. This will finish the interlocking of the bricks and help to remove any read more weed growth.


In addition, setting up a Brick or Paver sidewalk does not necessarily need a pro. The secret to setting up a Brick or Paver Walkway is to very first appropriately prepare the area where the bricks/pavers are to be set up. Now that you have a steady base, place a 1" pipeline or journal board the length of the sidewalk on either side of the sidewalk. These strips will act as your walkway border and help to maintain the integrity and shape of the walkway. Inevitably bricks/pavers will need to be cut or split when developing the sidewalk.

Leave a Reply

Your email address will not be published. Required fields are marked *